forked from amberisvibin/chibi-pc09
55 lines
2.0 KiB
Plaintext
55 lines
2.0 KiB
Plaintext
Quickstart to run CP/M and MP/M on the Z80-CPU simulation
|
|
|
|
1. Change to directory ~/z80pack/cpmsim/srcsim
|
|
make
|
|
make clean
|
|
This compiles the CPU and hardware emulation needed to run CP/M and MP/M.
|
|
|
|
2. Change to directory ~/z80pack/cpmsim/srccpm2
|
|
make
|
|
make clean
|
|
This compiles support programs (see below), installs named pipes and so on.
|
|
|
|
3. Make backup copies of your distribution disks!
|
|
cd ~/z80pack/cpmsim/disks/library
|
|
cp *.dsk ../backups
|
|
|
|
4. Change to directory ~/z80pack/cpmsim
|
|
cpm2 - run CP/M 2.2
|
|
cpm3 - run CP/M 3.0
|
|
mpm - this boots CP/M 2, run command mpm to boot MP/M 2
|
|
|
|
Usage of the support programs:
|
|
|
|
format: to create an empty disk image for the CP/M simulation.
|
|
input: format <a | b | c | d | i | j>
|
|
output: in directory disks files drivea.cpm, driveb.cpm,
|
|
drivec.cpm, drived.cpm, drivei.cpm and drivej.cpm
|
|
|
|
bin2hex:converts binary files to Intel hex.
|
|
|
|
receive:This is a process spawned by cpmsim. It reads from the named
|
|
pipe auxout and writes all input from the pipe to the file,
|
|
which is given as first argument. cpmsim spawns this process
|
|
with the output filename auxiliary.cpm. Inside the simulator
|
|
this pipe is connected to I/O-port 5, which is assigned
|
|
to the CP/M device PUN:. So everything you write from CP/M
|
|
to device PUN: goes into the file auxiliary.cpm on the
|
|
UNIX host.
|
|
|
|
send: This process is to send a file from the UNIX host to the
|
|
simulator. Type send <filename> &, and then run cpmsim.
|
|
The process writes all data from file into the named pipe
|
|
auxin, which is also connected to I/O-port 5, which is
|
|
assigned to the CP/M device RDR:. You may use this to
|
|
transfer a file from the UNIX host to the simulator.
|
|
Under CP/M type pip file=RDR: to read the data send from
|
|
the process on the UNIX host.
|
|
|
|
If you use PIP to transfer files between the UNIX host and the
|
|
simulator, you can only use ASCII files, because pip uses cntl-z
|
|
for EOF! To transfer a binary file from the UNIX host to the
|
|
simulator convert it to Intel hex format with bin2hex. This
|
|
can be converted back to a binary file under CP/M with the LOAD
|
|
command.
|